YUKEN方向控制阀注意事项

YUKEN方向控制阀注意事项 中国台湾油研YUKEN方向控制阀

安装螺栓亚盘安装泰PE阀门（DRG-02）只配有以下
"P" and cylinder port "A" (or "B") is set to 7 MPa
否则就会截断介质的正常流动
When sub-plates are not used, the
surface should have a good m achined finish
应使介质正常流动方向与阀体上指示的箭头方向相*
底阀应安装在水泵吸水管路的底端
For any other specific gravi
ty (G'), the pressure drop ( P') m ay be

YUKEN方向控制阀注意事项 中国台湾油研YUKEN方向控制阀

obtained from the formula below.
eover torque will be as right side table
子板是可用的从上表子板MNUM BER。
面应具有良好的米achined光洁度
Be sure to use the External Drain
Type Valve of spool type "2" and plug the tank port.
当不使用子板所述米ounting表
When the pressure of pressure port
Sub-plates are available. Specify
the sub-plate m odel num ber from the table above.

中国台湾油研YUKEN方向控制阀